Freebord Logo


STEP 1 - Your board includes


S2 Topper

Counter sunk mounting bolt

Round head mounting bolt

S2 height adjust screw 

Mounting nut

S2 base


5 Truck

Make sure you have everything

STEP 2 - Tools

You are going to need

STEP 3 - Poke Holes

Poke holes in the grip tape

*Be careful, the grip is pretty strong until it completely gives way. Make sure your hand is not behind the hole when your doing your poking.

STEP 4 - Casters

Mount your casters

STEP 5 - Trucks

Mount your trucks

STEP 6 - Bindings

Assemble your bindings

*Don’t be the noob that misses the slot in the bottom of the topper. Attaching the topper to the side of the base will result in the screws immediately bending. 

STEP 7 - Add Bindings

Install your bindings

*If you are worried about the direction of the graphic take note of which side you install the binding toppers on as there is a toe and heal side of the toppers.

STEP 8 - Pre-ride Check (every session)

Make sure your caster wheel is tightened, the bracket feels strong, and that the caster spins all the way around.

Check your edge wheel nuts for proper tightness.

Check to see if your kingpin nut is properly tightened

Insure your bindings are properly assembled and have the height adjust screws installed.

Pull the hanger arm away from the deck to make sure your easy blocks are installed and the springs are properly secure. 

Not what you were looking for?

Check out other explain pages.