STEP 1 - Your board includes

Deck
5-X Truck
Caster
S2 topper
S2 base
Countersunk mounting bolt
Round head mounting bolt
mounting nut
S2 height adjust screw
Make sure you have everything
- Deck x1
- 5-X Truck x2
- Caster x2
- S2 topper x2
- S2 base X2
- Counter sunk mounting bolt x16
- Round head mounting bolt x4
- Mounting nut x20
- S2 height adjust screw x4
STEP 2 - Tools

You are going to need
- Philips screwdriver
- 3/8” wrench -or- 10mm spanner
STEP 3 - Poke Holes

Poke holes in the grip tape
- Use your screw driver, mounting bolt, or something pokey to poke 8 holes in each end of the deck
- You can skip the 2 holes(in each end) highlighted in red. You will not be using these holes.
Be careful, the grip is pretty strong until it completely gives way. Make sure your hand is not behind the hole when your doing your poking.
STEP 4 - Casters
Mount your casters
- Use countersunk mounting bolts to attach your casters the deck
- Get all 4 screws tight-ish before tightening the bolts all the way
- Make sure the logos on the casters are both facing towards the center of the deck
STEP 5 - Trucks

Mount your trucks
- Use countersunk bolts in the holes towards the center of the deck
- Use round head screws to go through the S2 binding base, deck, and 5-X truck
- Get all 4 screws tight-ish before tightening the bolts all the way
The bindings should not be assembled yet, only use the metal binding base.
If the topper is installed you wont be able to get the screw driver on the inside bolts.
STEP 6 - Bindings

Install the binding toppers
- Add the plastic binding toppers to the binding baseplates using the slot in the bottom of the topper.
- Use the small silver screws to set the height of the binding toppers.
Don’t be the noob that misses the slot in the bottom of the topper. Attaching the topper to the side of the base will result in the screws immediately bending.
STEP 7 - Pre-ride Check (every session)

Check your edge wheel nuts for proper tightness.
Check to make sure all your mounting bolts are installed and tightened.
Make sure your caster wheel is tightened, the bracket feels strong, and that the caster spins all the way around
Insure your bindings are properly assembled and have the height adjust screws installed
Check to see if your kingpin faceplate is instlled and the pins are properly retained
Pull the hanger arm away from the deck to make sure your easy blocks are installed and the springs are properly secure.
Not what you were looking for?
Check out other assembly and tuning pages.